HPE Community
ProLiant Servers - Netservers
1751967 Members
4627 Online
108783 Solutions
New Discussion

HP Smart Array P410/512MB - Controller Lockup Error (code 851)

 
CRYPTON
Occasional Visitor

‎08-18-2016 04:07 AM

‎08-18-2016 04:07 AM

HP Smart Array P410/512MB - Controller Lockup Error (code 851)

I am encountering this error for the past a few days and it's always recurring.

I have a Proliant Microserver Gen8 with embedded B210i controller, because B210i doesen't support RAID6. so i added P410/512MB to connect five Seagete 5TB SATA HDD to make a RAID6 array.

At first i created arrays but after a night of system running, when we check the controller in the morning the above error shows up.

It's been happening for a few days. After upgrade to latest firmware 6.64 it still happens, so i decided to replace a new P410/512MB (v 5.12). But it still happens.

Any idea or solution for those who encounter the same error?

Thanks

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎08-18-2016 07:20 AM

‎08-18-2016 07:20 AM

Re: HP Smart Array P410/512MB - Controller Lockup Error (code 851)

per quickspec the mircoserver supports the P222.

http://www8.hp.com/h20195/v2/GetPDF.aspx/c04128132.pdf

 

HPE Smart Array P22/512 FBWC qualified for RAID support only for HPE ProLiant MicroServer Gen8.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.