HP microserverv Gen10 - Automatic start after powerfailure

[filic]

Hello,

anyone having an issue with setting Restore On Power Loss  to Last State not working?

When I simulate power outage (unplug and plug power cord) server starts automatically but whenever there is real power outage system is waiting for manual intervention and not starting automatically.

I have checked BIOS history revision from the beginning of Gen10 and do not see any fix related to this issue.

Current BIOS version I have is : ZA10A290

[Ash_1711]

>>Please let us know  which of the below scenarios you are facing the issue with & what is the result:

Scenario 1:
 Powered on the server.
 Set the “Restore on Power Loss” to “Power On”
 Wait for it to completely boot up
 Unplugged the power cable.
 Notice that the power button is AMBER and health LED blinking RED.
 Wait for the server to power off completely. LEDs OFF (Both Power and Health)
 Connected the power cable.
Result: ?
Note: Wait for the server to power off completely.

Scenario 2:
 Powered on the server.
 Set the “Restore on Power Loss” to “Power On”
 Wait for it to complete the POST
 Unplugged the power cable.
 Notice that the power button is AMBER and health LED blinking RED.
 Connected the power cable immediately while the LEDs are still blinking.
Result: ?
Note: Server is not completely powered off.

Scenario 3:
 Powered on the server.
 Set the “Restore on Power Loss” to “Last State”
 Wait for it to completely boot up
 Unplugged the power cable when the server is in OS
 Notice that the power button is AMBER and health LED blinking RED.
 Connect the power cable immediately while the LEDs are still blinking.
Result: ?