- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- Re: HPE microserver gen 10, ESXi and SMART
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-13-2019 12:39 AM
08-13-2019 12:39 AM
HPE microserver gen 10, ESXi and SMART
Dear Sir or Madam,
I'm Running a GEN10 Microserver with ESXI and a Quad HDD Raid in RAID 1 configuration on the internal Marvcel SATA controller. The Marvel - Volume which i created through booting into the interanl Marvel Bios is displayed within the ESXI - Host Hardwaredisplay. It can be used for VMs.
Unfuartunatly I'm not able to see the the bare metal Diskstatus within ESXI Host Hardware status. Is see only the Marvelvolume. Is there any way to display any HDD - Status / Health?
How about an separate SATA Controller Card HPE Smart Array E208i-p SR GEN10 or any other Card from the compatibility list: https://h20195.www2.hpe.com/v2/Getdocument.aspx?docname=a00017196ENW
Is it possible to see all Disk Stati connected to the Controllercard?
Regards,
Andreas Gaßner
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-14-2019 06:12 PM
08-14-2019 06:12 PM
Re: HPE microserver gen 10, ESXi and SMART
Hi Andreas,
The HPE ProLiant MicroServer Gen10 is not certified for VMware OS.
Refer Operating System Support feature on quickspecs page - https://h20195.www2.hpe.com/v2/getdocument.aspx?docname=a00008701enw.
Yes, the HPE ProLiant MicroServer Gen10 supports HPE Smart Array E208i-p SR Gen10 Controller.
But as the non-certified OS i.e. VMware ESXi is installed on the server, we cannot comment if expected HDD health/status would be visible.
HPE recommends to install supported OS on the server to avoid any unknown issues.
Regards,
KK