ProLiant Servers - Netservers

How to active sending SMTP traps on DL 380 G5

 
Heinz Wieczorek
New Member

How to active sending SMTP traps on DL 380 G5

Hello,

I have Win2003 installed and the SMTP service configured with our communitry string and a trap destination.

Now I would like configure SMTP so that it will send a trap in case of problems occur, eg. Disk failure (RAID).

Where would I start to configure this?
And how can I send a test trap ?

I have tried to find some SMTP \ trap settings in "System Management Homepage" - Settings - but the only SNMP option that I've found was disabled and WBMI was set as "data source"....

I use HP System Management Homepage v2.1.15.210

thank you

Heinz
2 REPLIES 2
Heinz Wieczorek
New Member

Re: How to active sending SMTP traps on DL 380 G5

I meant SNMP of course and not SMTP ...
Stephen Kebbell
Honored Contributor

Re: How to active sending SMTP traps on DL 380 G5

Hi,

I think you have to set that in the settings of the SNMP Service, under "Traps".
There you can specify a Trap Destination.

Regards,
Stephen