- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- How to format to Raid 1
ProLiant Servers - Netservers
1753280
Members
5618
Online
108792
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2002 11:52 PM
05-14-2002 11:52 PM
How to format to Raid 1
I have a HP netserver LH4 with two SCSI 9 Gig hd. Problems is how am I going to format these hd's to Raid 1?
Are there any sepcial tools which I must use to format? and how the procedure look like?
Thanks,
Nai
Are there any sepcial tools which I must use to format? and how the procedure look like?
Thanks,
Nai
zzz
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-16-2002 12:40 AM
05-16-2002 12:40 AM
Re: How to format to Raid 1
What are you going to install on that server. You should configure the raid set using ctrl+M when booting.
Then you should initialize the drives. Afterwards, you can use the navigator cd to create setup disks for several OS (w2k, NT4, ...). Then boot from the OS boot disks or from the cd, use the setup disk created and then format the drive during the setup.
Good luck,
Dries
Then you should initialize the drives. Afterwards, you can use the navigator cd to create setup disks for several OS (w2k, NT4, ...). Then boot from the OS boot disks or from the cd, use the setup disk created and then format the drive during the setup.
Good luck,
Dries
<< please try >>
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP