- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- Installing Server 2016 GUI on an HP Microserver Ge...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-24-2017 07:43 AM
03-24-2017 07:43 AM
Installing Server 2016 GUI on an HP Microserver Gen8
HI,
I've been trying to install windows server 2016 GUI (desktop experience) on the HP Microsever Gen8 via a bootable USB onto an SSD.
I can see and have setup the SSD in the HP provisioning software as a drive etc
I can also load the windows server 2016 via the USB from boot to start installation. But when it comes to selecting the drive, none are available.
I found a few tutorials online that allowed my to extract the drivers from the .exe files available on the HP support site. Loading the available drivers still does not display the hard drive.
What drivers are needed?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-17-2017 06:29 PM
05-17-2017 06:29 PM
Re: Installing Server 2016 GUI on an HP Microserver Gen8
This is the driver you'll need.
But if you're not going to use the RAID capability, you can just turn off the RAID functionality and enable the standard AHCI SATA controller instead. That way, you don't need any special drivers during installation.
I'm pretty sure in the AHCI configuration, the server will only boot from whatever drive is occupying the FIRST drive bay.
Microserver Gen8 G1610T, DL320e Gen8