HPE Community
ProLiant Servers - Netservers
1753394 Members
7198 Online
108792 Solutions
New Discussion

ML110 Raid-Win installs then can't boot

 
WES JONES
New Member

‎04-12-2007 02:42 PM

‎04-12-2007 02:42 PM

ML110 Raid-Win installs then can't boot

Proliant ML110 Intel Storage Matrix RAID (Ctrl-I to invoke) 3 drives set up,configured in Bios, WinServer R2 partitions, formats, installs and then can't boot from the drive.

Can't find operating system...

Ideas? Do I have to boot from a single non raid volume?

Thanks
0 Kudos
Reply
1 REPLY 1
E. Biemans
New Member

‎04-14-2007 12:40 AM

‎04-14-2007 12:40 AM

Re: ML110 Raid-Win installs then can't boot

Wes,

The maximum volume size of a bootable raid volume is limited (depends on de hardware/drivers). I've used a 32 GB RAID-1 boot partition on a ML110-G4 and this works fine !

Success
Eric
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.