ProLiant Servers - Netservers

ML150, 6-port SATA RAID, Win SBS 2003, cannot detect disks

 
CA1343886
New Member

ML150, 6-port SATA RAID, Win SBS 2003, cannot detect disks

I have a ML150 G2, model 366357-421, with (HP) 6-port SATA RAID controller and 2 160GB SATA disks.
I'm trying to install Windows SBS 2003, but it says it cannot find any disks to install on.
I have tried to supply the following drivers at setup (F6) of OS:
HP6-port_SATA_RAID_Controller_Driver_for_Windows_v4.2.1.7365
HPEmbedded_SATA_RAID_Controller_Driver_for_Windows_v5.2.3790.0
aac4.2.0.7344-2
but no luck.

I don't know what to try next, any ideas?
1 REPLY 1
Earl Cory
New Member

Re: ML150, 6-port SATA RAID, Win SBS 2003, cannot detect disks

I had no problem. I created the floppy following the instructions. The drives were visable after the SBS installation.

If you are intending to use the disks in a Raid 1 configuration, you need to configure the raid array before the installation. In that case, you need to go into the controller during post and create the array.

When you install SBS, put the floppy in when requested. The Raid-1 disk will be seen.