ProLiant Servers - Netservers

ML530 (G1) - SmartStart 5.50 - SA 5302 - Setup Help Needed

 
Patrick McCann
Occasional Contributor

ML530 (G1) - SmartStart 5.50 - SA 5302 - Setup Help Needed

I am trying to setup the ML530 using the SmartStart CD but cannot get the system to recognize the SA 5302. I thought I had the problem resolved last night. I removed the card, used the system erase utility and put the card back in. At this point on boot it saw the SA 5302 and I was able to set the controller boot order and the SmartStart process then continued. I was able to configure the array. Later in the SmartStart process I thought it had hung and rebooted. Since then I have not been able to have it recognize the SA 5302. I am back to the endless loop of no logical or physical drives found on the primary controller and the system erase utility must be run and I start the process all over again.
Can anyone tell me how to get the system to recognize the card and or what it is that I am doing wrong? Thanks for any help.