- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- ML530G2, confirming need for Smart Array Controlle...
ProLiant Servers - Netservers
1752268
Members
4573
Online
108786
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2005 02:59 AM
12-05-2005 02:59 AM
ML530G2, confirming need for Smart Array Controller
Acquired ML530G2 for use with Telephony application, redundancy requirements. I learned through HP forums that I cannot use the ACU to configure an array without a "Smart Array Controller" (none detected.) As delivered, drives can be accessed--but the ACU needs something else to configure them as an array.
I was hoping that someone could confirm, I am about to purchase "Compaq Smart Array 532 Controller 225338-B21", cost is low. I'll redirect the cage A SCSI cable (6 x 34G drives in cage A) to this controller...I already pulled slack out fom under the backplane.
Question: I was surprised that this was not standard, can anyone confirm this need?
Question: Will the 532 card's form factor match the ML530G2's PCI-x backplane?
I was hoping that someone could confirm, I am about to purchase "Compaq Smart Array 532 Controller 225338-B21", cost is low. I'll redirect the cage A SCSI cable (6 x 34G drives in cage A) to this controller...I already pulled slack out fom under the backplane.
Question: I was surprised that this was not standard, can anyone confirm this need?
Question: Will the 532 card's form factor match the ML530G2's PCI-x backplane?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-06-2005 05:34 AM
12-06-2005 05:34 AM
Re: ML530G2, confirming need for Smart Array Controller
Answered in array forum, 641/642 controller.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP