- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- Re: Microserver gen10 and P410 RAID boot
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-29-2018 02:30 PM
10-29-2018 02:30 PM
Microserver gen10 and P410 RAID boot
Hi,
I have a Gen10 Microserver with P410 RAID card installed and connected. I am able to configure the array as well as install linux on the array, but i am unable to boot the installed system. In both UEFI and Legacy modes there is no option to boot from P410 RAID . I can have /boot on a usb stick inside a server, but i am sure that there is a better solution.
Best regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-29-2018 02:51 PM
10-29-2018 02:51 PM
Re: Microserver gen10 and P410 RAID boot
@gausus wrote:Hi,
I have a Gen10 Microserver with P410 RAID card installed and connected. I am able to configure the array as well as install linux on the array, but i am unable to boot the installed system. In both UEFI and Legacy modes there is no option to boot from P410 RAID . I can have /boot on a usb stick inside a server, but i am sure that there is a better solution.
Best regards
That card was never tested in the server and isn't supported.
That being said, the card may work in legacy boot emulation mode. Go into the P410 settings and specify the boot volume. You willl need to install the OS while in legacy boot emulation mode, you can't install in UEFI mode and switch to legacy or vice-versa.