- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- NetRaid will not recognize drives.
ProLiant Servers - Netservers
1753962
Members
7308
Online
108811
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-08-2006 03:30 PM
08-08-2006 03:30 PM
NetRaid will not recognize drives.
I recently picked up a LH Pro 6/200.
It contains a single PPro 200, 96 Meg of ram and 3 - 4.2G Quantum HD's.
The problem is that the netraid card does not seem to see the drives. If I connect the drive cage to the onboard adaptec, it indicates the drives are available, but the netraid card never shows them. I have tried all three ports of the netraid. I ahve verified the switch settings. The ID's are set for 1,2,3,4,5,6. Upper and lower cage settings are correct.
I have reset the netraid to defaults, and tried several settings to no avail. If I put the SCSI cdrom on the netraid, it shows up as ID 5. The card must work, but never sees the drives.
I have tried all 3 drives as singles and several combinations of drives/slots. Nothing changes.
Any help on this would be appreciated.
Thanks in advance,
Bill
It contains a single PPro 200, 96 Meg of ram and 3 - 4.2G Quantum HD's.
The problem is that the netraid card does not seem to see the drives. If I connect the drive cage to the onboard adaptec, it indicates the drives are available, but the netraid card never shows them. I have tried all three ports of the netraid. I ahve verified the switch settings. The ID's are set for 1,2,3,4,5,6. Upper and lower cage settings are correct.
I have reset the netraid to defaults, and tried several settings to no avail. If I put the SCSI cdrom on the netraid, it shows up as ID 5. The card must work, but never sees the drives.
I have tried all 3 drives as singles and several combinations of drives/slots. Nothing changes.
Any help on this would be appreciated.
Thanks in advance,
Bill
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP