Netserver lh-3 with a netraid card

[Cliff Shoff]

We are running a Netserver lh-3 with a netraid card. We lost the logical drive information and cant get the machince to boot. Is there any way to get to logical drive information back?

[gringod]

cliff
During the POST you get to Control-M
This will access the raid utilities.
Under configuration you should be able to view the configuration
If there is still a valid setup you can select it and save it.
Remember the configuration is saved in two places, the drives and the NVRAM.
you should be able to use one them to get the old config

[Cliff Shoff]

Okay, we are trying ot reload NT 4.0. I have reinitilized a raid, but I can not get NT to find the hard drives. Any suggestions?

[gringod]

Cliff
If you do not have the HP navigator CD,
You will have to do it the long way.
Get the drivers for the Adapter and put it on a disk.
When you insert the NT 4.0 disk the first screen that comes up is a Press F6 for installing other cards.
Press F6,then when promtpted insert the disk in the stiffy drive and press enter.
Now when this is done the Logical drive should be visible to choose to format further on in the installation.
(But in your post you must dee that there is at least 1 logical drive shown.)