- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- No video on startup (POST)
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2015 03:59 PM
01-07-2015 03:59 PM
No video on startup (POST)
New microserver gen8. added 4 drives, usb kb and mouse, external optical drive (usb). Power up has no video - monitor is the same unit I am using to write this - set to auto config. Blue bar on bezel, solid green LED's (2) on front of mboard, back left rear LED's green. Two beeps after a couple of minutes. Have stripped all drives and addons with video attached - no difference. No other visible or audible indicators. Any ideas on how to move forwards??
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2015 04:45 PM
01-07-2015 04:45 PM
Re: No video on startup (POST)
The 2 beeps after a few minutes is normal. The beeps happen as POST finishes during the transition to boot the OS.
Something you might try is to access the console over iLO. If you can't see the console overiLO then you probably need a new system board.
If your not familiar with iLO here is what you need to do.
Plug iLO into your network. Without video, you will have to look at your DHCP server to figure out the IP. Get the iLO username/password from the toetag hanging on the back of the server. Browse to iLO and launch the remote console application to see what the unit does when you power it on.