ProLiant Servers - Netservers

ProLiant dl380 with SuSE SLES and StorageWorks 4000

 
Werner Brandt
Occasional Contributor

ProLiant dl380 with SuSE SLES and StorageWorks 4000

Hello,

we have an ProLiant dl380 g5 with SuSE SLES 9.

The Server have a FibreChanel Card and is connectet to a Compaq StorageWorks RAID Array 4000 series.

We have install the driver for the ProLiant DL380 G5 from the HP-Homepage.

Wenn the Module start, it send in the dmesg the following Information:
scsi0 : qla2xxx
qla2300 0000:12:01.0:
QLogic Fibre Channel HBA Driver: 8.01.02-sles
QLogic QLA2340 -
ISP2312: PCI-X (133 MHz) @ 0000:12:01.0 hdma-, host#=0, fw=3.03.18 IPX
scsi: unknown device type 12
Vendor: COMPAQ Model: ARRAY CONTROLLER Rev: 2.58
Type: RAID ANSI SCSI revision: 00
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 12

On an other Server (With SuSE SLES7), the Module say:
GBIC detected: Short-wave. LPSM 0h Monitor
Vendor: COMPAQ Model: LOGICAL VOLUME Rev: 2.58
Type: Direct-Access ANSI SCSI revision: 02
Vendor: COMPAQ Model: LOGICAL VOLUME Rev: 2.58
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi disk sda at scsi2, channel 0, id 0, lun 0
Attached scsi disk sdb at scsi2, channel 0, id 0, lun 1
SCSI device sda: 213392160 512-byte hdwr sectors (109257 MB)
sda: sda1
SCSI device sdb: 284522880 512-byte hdwr sectors (145676 MB)
sdb: unknown partition table

If it a Problem of the Module (Driver) or the Hardware ore did someone know a way, to solve the Problem?

Wenn the Arrays in the Storage did not see from the System, we kan not use tem :o(

Greeting,
W.Brandt