ProLiant Servers - Netservers

Proliant 800 (yes very old)

 
CA1238065
New Member

Proliant 800 (yes very old)

I can't find any comprehensive help for adding a new processor and forgive me im new, 2 processor slots one processor 450mhz other same after installing other into slot(secondary) and installing second ppm then attempting to boot it give error message processor in wrong slot when i am sure both are in right slot can some one tell me what settings i need to change for it work?

all i did was insert the processor and ppm where and what do i need to change (i.e. switches, bios, or maybe bus frequency) please don't tell me to change the switch to match but which switch and what to change it to...i lost the manual

thanks for listening
2 REPLIES 2
CA1076661
Frequent Advisor

Re: Proliant 800 (yes very old)

Processor with Heat Sink 450/100 179780-001
Processor Power Module (350E,400,450) 327660-001
System/Processor Board only (350e to 500 MHz) 320978-001

Bus/core Ratio switch settings

1 2 3 4 5 6
on off on off off off

After installing the dual processor run the system configuration utility (F10). and save the setup



CA1238065
New Member

Re: Proliant 800 (yes very old)

Thanks will try

(never thought any forum could help with such a old model thnx again)