ProLiant Servers - Netservers

Proliant DL 140

 
CA1337529
New Member

Proliant DL 140

This server has a display problem but everything else works fine.
is there a way of installing a display card or do i have to replace the board or is there another way of solving the problem.
Your assistance will be highly appreciated
2 REPLIES 2
Tarek Kawach
Honored Contributor

Re: Proliant DL 140

DL140 G1
- Graphics is
Integrated ATI RAGE XL Video Controller with 8MB SDRAM Video Memory

DL140 G2
- Graphics Is also.
Integrated ATI RAGE XL Video Controller with 8MB SDRAM Video Memory

- They both use the windows drivers
- check in device manager and see what driver is listed and the type for your monitor.

- try to use standard monitor or install drivers for monitor etc.

- Possible also reduce the monitor refresh rates etc.

- get the latest driver for the card from ATI>


Don't know what display issues you have; Please explain further and where the problem is.

Alos what monitor you are using and the drivers version fro the Video and monitor.

- Also the firmware for the server and if it is G1 or G2.

Hope this helps.


Best regards,

Tarek.
Hey, look a light at the end of the tunnel.
CA1337529
New Member

Re: Proliant DL 140

Please note that the server does not display anything at all. Its like it does not send a signal, as in the monitor connected to it shows a orange light.
Any assistance