ProLiant Servers - Netservers

Proliant DL 360 raid configuration

 
Milind Sanaye
New Member

Proliant DL 360 raid configuration

Can anyone plz guide me how to check n configured the array in Proliant DL 360?

I ve tried several methods to check, like Hp system management, array configuration utility but the problem couldn't resolved.

My device management shows only one harddrive.

During the post screen its shows both the scsi drive. And when u press F8 & view the status it shows the drive is ready.

We have tried several possible steps to configured the raid level 1 but still it's not getting configured.

2 REPLIES 2
Ron Moody
Frequent Advisor

Re: Proliant DL 360 raid configuration

ACU is "the" way to work with an arry problem.

If you have prooved the 2nd drive is good, try pulling both hard drives,restart, go into the BIOS setup, Advanced, and "Clear NVRAM".
Put the drives back in, restart, and re-configure your array with ACU....
Milind Sanaye
New Member

Re: Proliant DL 360 raid configuration

Thank u so much for reply.

Actually it was configured properly but I was looking for raid configuration in windows diskmgmt.

And when I installed HP System Manager, after that the disk activites become visible.