Setup did not find any hard disk drives when I install SATA RAID driver for Windows 2000 server

[TONY LEUNG_3]

Dear,

I Try to install my server with W2000 server.
I configured and created a RAID 1 array with 2 SATA hard disks successfully.
I download the new SATA RAID Driver for Windows 2000 from http://h18004.www1.hp.com/support/files/server/us/download/22263.html
I push F6 and install new mass storage driver for the raid controller during the w2000 installation, I have installed a floppy drive and it works as usual. It can recognize Adaptec RAID controller driver but when it shows “To set up windows 2000 now Enter” and I pressed Enter, the following screen shows:

Windows 2000 Server Setup

Setup did not find any hard disk drives installed in your computer.

Make sure any hard disk drivers are powered on and properly connected
To your computer, and that any disk-related hardware configuration is
Correct. This may involve running a manufacturer-supplied diagnostic
or setup program.

Setup cannot continue. To quit Setup, press F3.”


Does anyone know a solution for this problem? Is there any software or cable I missed, I am using two separate SATA cables to connect the two hard disks. I am sure that there is no problem with the hard disks because I can successfully install W2k server when I disable SATA RAID function.
I only have a HP ProLiant ML110 G2 Server support CD with the package, is it correct?

Thanks!

[Oleg Koroz]

What you use 4 or 6 Port Card?

http://h18023.www1.hp.com/support/files/server/us/download/22353.html

after F6 and S you see correct controller ?

Is there any other controllers installed? Boot priority?