- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- SmartArray 3200 Replacement Procedures for Prolian...
ProLiant Servers - Netservers
1753859
Members
7575
Online
108809
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-22-2011 05:12 PM
03-22-2011 05:12 PM
SmartArray 3200 Replacement Procedures for Proliant 6500R
I have a bad 3200 Smart Array controller (340855-001) that needs to be replaced on my Proliant 6500R Server. Yes this is very old server and no longer under warranty. I am looking for procedures on safe replacement and steps on what to do to avoid any data loos. Any advice/link is appreciated. Is thre a cash module that needs to be moved to new RAID board?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-24-2011 03:52 AM
03-24-2011 03:52 AM
Re: SmartArray 3200 Replacement Procedures for Proliant 6500R
Make sure you have similar part number of the controller. Get a copy of SMARTSTART 5 just in case you have to run the configuration utility. With server powered off, replace the controller (must be on the slot). If there's cache module from the original card-move it to the new controller. During boot-up process, you should see the controller and number of attached device. NOTE: If you do not see the SA3200 during boot up, you have to reboot the server with SmartStart 5 CD and run the configuration utility and save it. GOOD LUCK!!
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP