HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers - Netservers
Showing results for 
Search instead for 
Did you mean: 

Xenserver 6.5.0 on myHP Microserver G1610T Gen8 - "Problem With Location" while install

Occasional Visitor

Xenserver 6.5.0 on myHP Microserver G1610T Gen8 - "Problem With Location" while install


I'l like to install Xenserver 6.5.0 on myHP Microserver G1610T Gen8, but when trying the install from usb-stick it fails with, when it gets to the "Select Instllation Source":

"Problem With Location
Setup was unable to acess the location you specified - please check and try again".

After reading the following posts I enabled AHCI support in BIOS


But this had no effect!

Is it possible to install from USB-Stick in AHCI-Mode or does this only work from DVD-drive. I would be very grateful, if I could get the BIOS-Settings (especially changes from default).

In case of only DVD-drive support: What kind of DVD-drive is neccessary, hat are the neccessary standards to comply with in order to get it working an the Proliant-Server.

Every help is highly appreciated! Thank you in advance und best regards from Germany!