ProLiant Servers - Netservers

iLO 3 and RIBCL

 
KevinVail
New Member

iLO 3 and RIBCL

We are using a Perl script to send commands to the iLO via RIBCL, following the instructions in the manual. This works fine on iLO 2 systems, but the new iLO 3 systems completely ignore the fact that I'm sending them anything. I don't even get an error message back. The only configuration difference I can see between the iLO 2 and iLO 3 systems is that the 2's all have the advanced license, while the 3's are all basic. Is this the difference? If not, can anyone point me in a direction to start looking for why this happens? All new servers this year are going to be 3's and we're kind of counting on this working. Any help appreciated!

2 REPLIES 2
ChickenJuice
New Member

Re: iLO 3 and RIBCL

Yes. You need to make sure your iLO is licensed otherwise nothing will work.

Jimmy Vance
Honored Contributor

Re: iLO 3 and RIBCL

There was a change in the web services in iLO3 so you need an updated locfg.pl script. You can grab the update script from here

 

HP Lights-Out XML PERL Scripting Sample

 

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=US&swItem=MTX-fcd62e4971894807a3a1fde8c0&mode=4&idx=1&prodTypeId=18964&prodSeriesId=1146658

 

No support by private messages. Please ask the forum!