ProLiant Servers - Netservers

iLO DEAD after firmware 1.82

 
iLOBUG
Occasional Contributor

iLO DEAD after firmware 1.82

Need help with a dead ilo.
It was running v1.62, and I upgraded to 1.82.
iLO reboots and did not come back.
Did others without any issues.
It was set to static IP, so I do not believe it picked up a different address.
Attached to the management port on the front of the blade, no response from iLO.
Any help on next steps would be greatly appreciated.
Thanks
1 REPLY 1
Gary Cantwell
Honored Contributor

Re: iLO DEAD after firmware 1.82

Hi Sean,

Welcome to the Forums!

You could also post this one in the dedicated iLO Category of the ITRC Forums:

http://forums1.itrc.hp.com/service/forums/categoryhome.do?categoryId=298

The experts there will have some suggestions for you,

Hope this helps,

Gary