restarts on Proliant DL380 G4

[fguirado]

Hello, I have a proliant DL380 G4 with windows server 2003 enterprise edition. Since I installed service pack 2 the server crash very often. In the event viewer I can see a 1003 error with this information: error 000000d1, parameter 1 00000000, parameter 2 d0000002, parameter 3 00000000, parameter 4 f78562e4.

I think this is a driver problem, but I don't know which driver I must change.

thank you

[Daniel Leblanc]

The system attempted to access pageable memory using a kernel process IRQL that was too high. The most typical cause is a bad device driver (one that uses improper addresses). It can also be caused by caused by faulty or mismatched RAM, or a damaged pagefile.

http://support.microsoft.com/kb/810093/en-us
http://support.microsoft.com/?kbid=916595&sd=RMVP

You could try removing sp2 and try see if it still does it,then try re installing sp2

Daniel

PS:Don't ferget tplease to apply you re points,there are situated next to every messages in you re thread ,next to date and time has UNASSIGNED.the button to apply is on the botton of the page.

[Guido Elia]

And check with the last firmware and support packs cds