HPE Community
Server Management - Remote Server Management
1753603 Members
6408 Online
108797 Solutions
New Discussion

Re: Configuring ILO on BL20p through diagnostics port

 
Radiohead316
New Member

‎01-13-2009 10:11 AM

‎01-13-2009 10:11 AM

Configuring ILO on BL20p through diagnostics port

Hello,

I have a BL20p G2 that I need to configure the ILO on locally. I have received the diagnostics cable to connect to the server, but I'm not sure exactly what to do from here.

Do I connect through the serial or network port? What are the steps to configure the IP's?

Thanks.
0 Kudos
1 REPLY 1
Radiohead316
New Member

‎01-13-2009 08:50 PM

‎01-13-2009 08:50 PM

Re: Configuring ILO on BL20p through diagnostics port

There is an IP address on the dongle and you connect with a straight through RJ45 cable. You must configure your network to be on the same range and subnet.

Thanks.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.