Remote Lights-Out Mgmt (iLO 2, iLO, RILOE II) Forum
Showing results for 
Search instead for 
Do you mean 

Power Enclosure in rack view not shown

Advisor

Power Enclosure in rack view not shown

I have a BL p-Class rack and in the rack view of the iLO web interface of any blade, I see all enclosures with the blades and the switches but not the power enclosure.

Most of the iLO firmware are 1.82, at least one is 1.88.

See attached, my rack view...
4 REPLIES
Honored Contributor

Re: Power Enclosure in rack view not shown

Hi Yvan Lefevre,

1 Ensure that the management link cable is connected from the Power enclosure to the Blade enclosure.

2 Try reseating the cable and check.

3 Try reseating the Power enclosure Management Module.

4. Update the firmware of the Power and Blade enclosure to the latest 2.30.

Server Blade and Power Management Module Firmware:
http://h18023.www1.hp.com/support/files/server/us/download/24088.html?jumpid=reg_R1002_USEN

Regards,
Raj.
Advisor

Re: Power Enclosure in rack view not shown

Thanks Raj,

1. There is a cable, the amber led never blinks, the green one is on. If I look at the other enclosures, the amber led periodically blinks.

Can you check on yours ? (btw, it's a 3U power enclosure I have)

2. I did remove and replug the cable but perhaps it's faulty, i'll try another one tomorrow.

3. how do you do that ???

4. firmware is already 2.30
Advisor

Re: Power Enclosure in rack view not shown

I did manage to get an hp engineer on site for this.

The only way to have any information about the power enclosure was to connect directly to the management module with a serial cable.

Result: the power enclosure firmware was 1.00 !!

He did replace the management module (because he wasn't sure he could upgrade from 1.00 to 2.30) and upgrade the new one to 2.30 and the problem was solved.
Advisor

Re: Power Enclosure in rack view not shown

Problem solved!
//Add this to "OnDomLoad" event