Remote Lights-Out Mgmt (iLO 2, iLO, RILOE II) Forum
Showing results for 
Search instead for 
Do you mean 

RILOE ADD_USER error in CPQLOCFG

Frequent Advisor

RILOE ADD_USER error in CPQLOCFG

I am attempting to add a new user with Administrative privilages to a RILOE with firmware 2.53A. I have an XML file which follows the standard in the sample files and doc. I am using CPLOCFG.EXE ver 2.25.

When I include the line



The script errors out at that point claiming a Syntax error at or near this line. If I remove this line, the script runs but the user ID does not have the Configure Riloe Access right when created.

If I use the older "SUPVERVISOR_PRIV value="Y" from the original RILOE User Guide, I get a message that this command is no longer supported and the User Right is not update.

How can I set that Configure Riloe Access right using the script to run through SIM without an error.
2 REPLIES
Frequent Advisor

Re: RILOE ADD_USER error in CPQLOCFG

OK...shortly after posting this, I found another posting that showed an example where the syntax was "CONFIG_RILO_PRIV". That worked. I did not find that in any of the formal docs or sample files. They all documented it as CONFIG_ILO_PRIV".
Frequent Advisor

Re: RILOE ADD_USER error in CPQLOCFG

See last note.