Remote Lights-Out Mgmt (iLO 2, iLO, RILOE II) Forum
Showing results for 
Search instead for 
Do you mean 

SNMP and RILEO II cards

Occasional Contributor

SNMP and RILEO II cards

All,

I can perform an SNMPWALK on iLO (integrated Lights Out), but cannot do the same for the RILOE II cards. Is there something special to enable on the RILOE II cards to get them to respond to SNMP queries?
Thanks
4 REPLIES
Trusted Contributor

Re: SNMP and RILEO II cards

Make sure you have the "SNMP Pass-through Status" Enabled in the SNMP Settings page.
Occasional Contributor

Re: SNMP and RILEO II cards

I do not have an "Enable SNMP Pass-thru" on the RILOE II cards. This option only exists on an iLO. The firmware on the RILOE II boards is v1.11. Do I need a later version to support the "Enable SNMP Pass-thru" option? Thanks.
Occasional Contributor

Re: SNMP and RILEO II cards

Answered without checking. There is an updated firmware: 1.12. This firmware supports "SNMP Pass-through Status". This is now enabled (it is enabled by default after flash updating the firmware). I still cannot SNMPWalk the RILOE II card, though I can SNMPWalk the server itself. SNMPWalk supports a debug mode and from watching the debug mode, it appears that the RILOE II card never responds to a SNMP query. The server is running v.3.1.1.0 of the HP Remote Insight Lights-Out driver. Do I need an additional driver on the server for the SNMP Pass-through to work? Thanks.
Trusted Contributor

Re: SNMP and RILEO II cards

SNMP is working. Problem is on the RILOE II side. I would uninstall, delete the old cpqrib2.sys driver, and install a new one. The old driver may be corrupt.