iLO lost after 1.89 firmware upgrade

[Tusc]

Hey guys - I am using HPONCFG to configure iLO online. I run my XML scripts against ver 1.41 and all is fine; however, I lose iLO entirely after upgrading to 1.89 on several (not all) servers. Any ideas?

Here are the error in my logs:

"No RILOE II board found.
ERROR: No RILOE-II/iLO was found."

If I rerun the 1.89 installer:

"The software will not be installed on this system because the required hardware is not present in the system or the software/firmware doesn't apply to this system."

[M.S.Srivatsa]

Question
1.How did you perform the firmware
upgradation ?
1.Did you use HPONCFG for doing firmware upgrade ?
or
2.Did you use iLO browser interface for
doing the firmware upgrade ?
or
3.Did you use iLO online flash component
for doing the firmware upgrade ?
Please let us know.

[M.S.Srivatsa]

Question
Please let us know the servers on which
this problem is reproducible ?

[M.S.Srivatsa]

Question
Please let us know the servers(server
model) on which this problem is
reproducible ?

[Tusc]

I used the online flash method. No browser or HPONCFG.

[acartes]

I suggest you open a support case for this problem.

[Anders_35]

Did you get a solution to this? We have the same problem with several servers.

To add to the misery, I tried to power one of the servers down and removed/reinserted it in the enclosure.
Now it is dead, the power button doesn't work....(but it has power)

[Tusc]

Nope... So far rebooting the server has caused the server to see the ilo board once again. According to HP, this is a common issue when upgrading from versions older than 1.60.