Openflow command is not working in 2920-24G J9726A

[openflow]

I want to set up SDN set up , i have two hp switches ( 2920-24G J9726A), and controller. By serial port terminal i can access the console of the switch . In hp switch the command openflow is not working . I have tried enabling openflow but CLI  is not detecting openflow command and giving error that it is invalid input .

  HP-2929-24G(config)# openflow

  HP-2929-24G(config)# show openflow

       invalid input : openflow

Please if any one can guide me how to enable openflow command and also steps to link both the switches through trunk .

Thanks

P.S. This thread has been moved from ProCurve / ProVision-Based to SDN Discussions. -HP Forum Moderator

[bibma]

Whats your firmware? - As per the release notes seems its part of WB.15.12.0010 available on the portal..

[Javed Padinhakara]

adding to previous post.....from HP's Openflow Admin Guide I can see that the support for 2920 series was added in the following firmware versions

K/KA.15.12 and WB .15.12

and you can find detailed steps to carry out the configuration as well in the same guide...

Ref: http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c03991489-1.pdf

HTH..

-J

[EricAtHP]

WB.15.12 has support for OpenFlow 1.0

WB 15.14 has support for OpenFlow 1.3

You can download software for the 2920 here: https://h10145.www1.hp.com/downloads/SoftwareReleases.aspx?ProductNumber=J9836A