HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Server Management - Remote Server Management
Showing results for 
Search instead for 
Did you mean: 


Occasional Visitor


hi all

after a configuration change in the ilo board ( enable passtrough ) , ilo reseted not properly.
the ilo board is no longer reachable by the network.
i can still connect the host server of this ilo board.
I tried to execute the CPQLODOS from the cmd prompt on the ilo host server.
-> ERROR: No RILOE/RILOE II/iLO was found.
whats wrong ?
or any other how to's , for remotly "reboot / reset " the iloboard ?

Junior Yharte
Trusted Contributor


Almost sounds like iLO got disabled ...do you get the F8 prompt in POST? There will also be a message that iLO has been disabled if this is the case. You will need to set the security over-ride switch to get around this. It is documented on the inside of the server hood (cover). Let me know if you still need some help.