HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Server Management - Remote Server Management
cancel
Showing results for 
Search instead for 
Did you mean: 

ILO/HPONCFG help please...

 
Tim Toohey
Occasional Visitor

ILO/HPONCFG help please...

One of our servers had it's system board replaced recently and the tech could not figure out how to configure ILO after replacement. I have HPONCFG installed and working on the target server, but I am unable to get a response from the ILO in a browser. All I have done is configure a static IP (it is now pingable) and add a user account.

Is there a way to reset the board to factory defaults? I haven't found a script that does this. Should the web page be enabled by default? Thank you for any help you can provide. I can post configs as well, if desired.
1 REPLY
Tim Toohey
Occasional Visitor

Re: ILO/HPONCFG help please...

I didn't look very hard. hponcfg /reset was what I was looking for...found it right away.