- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Remote Server Management
- >
- LO100 retrieving power status over CLP/telnet/ssh
Server Management - Remote Server Management
1753973
Members
8018
Online
108811
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2009 12:11 AM
04-15-2009 12:11 AM
LO100 retrieving power status over CLP/telnet/ssh
Hello,
I'm trying to retrieve the power status of ML115G5/LO100 boxes via the CLP using telnet or ssh, without success so far!
I'm able to successfully power up and power down the device via the CLP using comamnds 'start /system1' and 'stop /system1' etc.
However, for the system1 property 'enabledstate' is always set to 'enabled', regardless if the system is powered up or down.
My expectation from reading ILO materials is that the property 'enabledstate' should be set to 'disabled' if the machine is powered up.
Any suggestions?
I'm trying to retrieve the power status of ML115G5/LO100 boxes via the CLP using telnet or ssh, without success so far!
I'm able to successfully power up and power down the device via the CLP using comamnds 'start /system1' and 'stop /system1' etc.
However, for the system1 property 'enabledstate' is always set to 'enabled', regardless if the system is powered up or down.
My expectation from reading ILO materials is that the property 'enabledstate' should be set to 'disabled' if the machine is powered up.
Any suggestions?
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP