Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
Server Management - Remote Server Management
cancel
Showing results for 
Search instead for 
Did you mean: 

LO100 retrieving power status over CLP/telnet/ssh

Kiroban
Occasional Visitor

LO100 retrieving power status over CLP/telnet/ssh

Hello,

I'm trying to retrieve the power status of ML115G5/LO100 boxes via the CLP using telnet or ssh, without success so far!

I'm able to successfully power up and power down the device via the CLP using comamnds 'start /system1' and 'stop /system1' etc.

However, for the system1 property 'enabledstate' is always set to 'enabled', regardless if the system is powered up or down.

My expectation from reading ILO materials is that the property 'enabledstate' should be set to 'disabled' if the machine is powered up.

Any suggestions?