- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Remote Server Management
- >
- Lights our DR environment
Server Management - Remote Server Management
1752567
Members
5356
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2005 11:24 PM
03-17-2005 11:24 PM
Lights our DR environment
I have been working on a standby disaster recovery environment. We have developed a PXE boot load that uses a RAM drive and loads the HP drivers and allows us access through the iLO/RILO in each device. I cannot get the SNMP traps to reach our management console. We are trying to forward the Insight traps to a unicenter console. If anyone here has a better solution that I can put in quickly, I would love to here it.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-25-2005 03:28 AM
03-25-2005 03:28 AM
Re: Lights our DR environment
You can send SNMP traps through iLO. Check the SNMP/Insight Manager page settings where you can specify SNMP destination addresses. Then you can issue a test trap to see if it picked-up by the management console.
From that point on, if you are using the HP drivers and agents, you should be able to do MIB gets and walks and SNMP traps through the iLO network interface.
From that point on, if you are using the HP drivers and agents, you should be able to do MIB gets and walks and SNMP traps through the iLO network interface.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP