HPE Community
Server Management - Remote Server Management
1751712 Members
4995 Online
108781 Solutions
New Discussion юеВ

Re: RILOE II firmware upgrade error

 
Sean Fitzpatrick
New Member

тАО02-26-2004 04:53 AM

тАО02-26-2004 04:53 AM

RILOE II firmware upgrade error

Trying to upgrade firmware from 1.11 to 1.12 on several RILOE II's. All succeeded but one, and I've tried all the steps to reconfigure the card (DR mode, reset to factory settings). Any help or suggestions?
0 Kudos
Reply
3 REPLIES 3
Junior Yharte
Trusted Contributor

тАО03-10-2004 03:36 AM

тАО03-10-2004 03:36 AM

Re: RILOE II firmware upgrade error

Can you be more specific as to the error you├в re getting? Does the rompaq (diskette) upgrade fail as well? You can force it by flipping switch 3 on the R-II and booting up w/ the firmware disket
0 Kudos
Reply
Sean Fitzpatrick
New Member

тАО03-12-2004 02:28 AM

тАО03-12-2004 02:28 AM

Re: RILOE II firmware upgrade error

Yes, I tried that as well, with no luck. Right now I have set switches 3 and 4 to on to bypass the error but I still need to reconfigure the card. The error I get when all switches are set to normal is 'Error 10002: The card is not responding', or similar wording.
0 Kudos
Reply
Junior Yharte
Trusted Contributor

тАО03-26-2004 07:28 AM

тАО03-26-2004 07:28 AM

Re: RILOE II firmware upgrade error

Sean, switch 3 and the rompaq disk should correct the problem unless there is a physical problem with the board. Is there a message when the flash starts from the disk or does it say no board found?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.