Update ILO Amplifier Pack to 1.80: High CPU Usage - ESX

[UlrichThomas]

hello, last week my ILO aplifier pack was updated to version 1.80 automatically. 
After that the CPU load is over 80% the whole time. Reboot didn't reduce the load.

Are there any suggestions what I can do?

[Birchi]

We have experienced the same issue with the ESX.

CPU Load Average 77.25

[--Matt--]

Mee too.  Fresh install (1.80)  still shows 80% plus CPU usage.

[perbengtsson]

I see a high CPU utilization running the appliance in Hyper-V too.

It has 4 vCPUs and mine is rock solid at 50% utilization. 

[MRidsdale]

Same here. @HPE working as intended?

[UlrichThomas]

I've opened a case with HPE a week ago. Case Nr 5354033169
But there hasn't been anyone who looked into the appliance to check which process is creating a lot of load..
L2 asked me if there are tasks in vmware, which version of esxi we use, load on the host.
They didn't catch the problem in the amplifier pack 1.80

[MarioJAF]

Same issue in our iLO Aplifier Pack vSphere appliance.
After Update to 1.80 yesterday it is constantly over 80% cpu load. After a restart the load goes up to 80% again.

[ChuckMalpass]

Seeing the exact same thing for more than a week.  Finally had to shut it off

[SanjeevGoyal]

Hello,

I saw you already logged case with the HPE tech support.

HPE RTCC L2 is working on that.

I would request follow with the RTCC engineer.

[--Matt--]

Ok, I have now also raised a ticket.  Case ID: 5354242813