Update iLO Amplifier from 1.81 to 1.90 - Issues

[Birchi]

After updating from v1.81 to 1.90 ...

• no servers are visible anymore.
• CPU is between 50% and 100%.
• General Settings: Failed to load performance settings
• Reports: Failed to Download Report

[Suman_1978]

Hi,

First things first, have you checked the compatibility?
https://support.hpe.com/hpesc/public/docDisplay?docId=c05384819

Thank You!
https://support.hpe.com/hpesc/public/home

[Birchi]

Hi Suman_1978

The amplifier has updated itself automatically. For this reason I trust HPE that the compatibility is OK.

Kind Regards

birchi

[Zimo]

We experiencing exactly the same problems and compability is ok.

Br,

Simo

[Sven_Probst]

Same problem here, after rebooting the virtual-appliance you can see it is adding the devices. After a few minutes (counting up 300 added servers and more)  it just display "0 Server" and the cpu-usage is about 100% after that point.

[jprabhak]

I would suggest to raise a support case 

regards

[Birchi]

HPE Support case 5355494764 has been created

[sudhirsingh]

Hi,

High CPU utilization has been fixed in 1.81, check if it can be redeployed and add server again.

https://support.hpe.com/hpesc/public/docDisplay?docId=a00112065en_us&docLocale=en_US

Regards,

Sudhir

[Zimo]

The high CPU was fixed in 1.81 but it came back in 1.90. At least for us too. And not only that, as mentioned earlier, right after reboot, it's running thru the servers but suddenly (after a few minutes) the number drops down to zero. I also created a case.

After loosing the whole inventory, trying to readd hundreds of servers to appliance running on 100% CPU, is not actually a solution in my mind.

Br,

Simo

[Zimo · Accepted solution]

Resetting to factory defaults was the official "solution" from HPE. 

Advisory: HPE Integrated Lights-Out (iLO) Amplifier Pack - All Discovered Servers May Not Be Displayed on the Servers Page and High CPU Utilization May Cause iLO Amplifier Pack Unresponsiveness

-Simo