- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Remote Server Management
- >
- Re: configuring ILO 2 to send alerts
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-14-2011 02:11 PM
09-14-2011 02:11 PM
configuring ILO 2 to send alerts
We are using SCOM 2007 to monitor our servers. We have a server in a dmz running ISA 2006 firewall. Because it is against best firwall practice to open up ports between localhost and the intenal enterprise network I cannot put a SCOM agent on the server. We do however, have a ILO 2 configured that i have direct access to. Can i configure the ilo to send snmp traps to SCOM 2007. Will ILO send out alerts for blown power supply, bad fan, bad disk drive, thermal events etc. Has anyone done this before.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-03-2011 03:00 AM - edited 10-03-2011 03:14 AM
10-03-2011 03:00 AM - edited 10-03-2011 03:14 AM
Re: configuring ILO 2 to send alerts
Hi Larry,
iLO doesn't have an SNMP stack but it can forward SNMP alerts. What we do is configure SNMP in the OS to alert to 'localhost' and configure iLO to 'forward SNMP alerts' to our CMS (we don't use SCOM but the same principle should apply). Anything that the OS alerts for will make it to SCOM if your network allows it to.
Regarding whether iLO will report on blown power supplies etc - I'm not 100% sure about that, but assuming that's not something the OS would detect (and therefore send SNMP alerts for) I'm guessing you might need the HP Mgmt Agents installed (PsP) and iLO configured to fwd mgmt agent alerts, but while that will work fine with HP SIM, I've no idea how it would interact with SCOM..