Server Management - Remote Server Management
1748230 Members
4092 Online
108759 Solutions
New Discussion юеВ

iLO "Information Not Available" and auto resets

 
Dian_Consulting
Occasional Advisor

iLO "Information Not Available" and auto resets

After power-on server (ML350 g6) fails to start.
iLO2 works.
in "System Information" -> "Summary" section I see "Information Not Available" message for all entries.

"iLO 2 Event Log" shows
"Server power restored. " and "Server reset." entries without any my actions

What's going on and how to get our server back to work?

 

3 REPLIES 3
Dian_Consulting
Occasional Advisor

Re: iLO "Information Not Available" and auto resets

Screen is black all the time

Dian_Consulting
Occasional Advisor

Re: iLO "Information Not Available" and auto resets

Any ideas?

ronissac
Trusted Contributor

Re: iLO "Information Not Available" and auto resets

Hi , 

Make sure the BIOS and ILO firmware is updated to Latest

If the issue still persists, Try to boot the server is minimum configuration (1 CPU, I DIMM , no HDDs) 

Try adding the parts one by one and check if the issue persists. This way you can isolate the faulty part

Regards

Ronny

If you feel this was helpful please click the KUDOS! Thumbs below!


I am an HPE employee
Accept or Kudo