Server Management - Systems Insight Manager
cancel
Showing results for 
Search instead for 
Did you mean: 

Automatic Event handling - not able to do status changes from critical to normal

Steve_P
Advisor

Automatic Event handling - not able to do status changes from critical to normal


Hi All,

I was able to configure the event notification for the severity change from critical to normal. I am wondering if you have successful done one.

Here is the scenario:
Two HBAs in the server

If one of the HBA is disconnected from the SAN switch, I received status changes which is critical. But when I reconnected it I did not get any normal events even though I have setup a normal severity event.

I did get both for the ping event.

Thanks,

Steve
1 REPLY
David Claypool
Honored Contributor

Re: Automatic Event handling - not able to do status changes from critical to normal

You shouldn't rely on status changes to pick that up. If you have your trap destinations set properly, you will get specific events about what is going on, not just status changes. Status polling is just a backup mechanism.