Blade Enclosures

[Steve McBride]

Hi All, I have three blade enclosures fullly populated. I'm only able to see the top and bottom enclosure in insight, but not the middle one.
the strainge thing I can see all the blades in the middle enclosures. all the firmware and software for the blades and enclosures are up to date.

Any Idea's?

[Adrian Clint_1]

Here's one I think works.

Go into the ILO on a blade in the middle chassis. Go to the SNMP/Insight Settings page.

Set the IP address of your SIM server and enable all the buttons below. Save, refresh the screen and then click on the button to send a test trap.

[Steven Baillie]

hi

If you go into a the ILO of the blade that is in slot 1 of the bottom enclosure.

got to the Bl p class tab
and choose rack view.

Is this view the correct view of your rack and enclosures.


If this is correct then the cabling connecting your ILO's is correct.


If this is not correct then the cabling is wrong and should be checked.



steven