HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

HPSIM 5

 
SOLVED
Go to solution
M.Drori
Occasional Contributor

HPSIM 5

Hi,
I want to install HPSIM 5 along with my old CIM7. Upgrade cannot be considered...
Can I use the same SNMP traps? I manage around 250 servers and looking for the fastest and safest way to use a new and improved monitoring system.

Mike
3 REPLIES
Craig McK
Trusted Contributor
Solution

Re: HPSIM 5

Hi Mike,

To start with we just added in an additional trap destination to the existing communities - both CIMs logged the events OK. Haven't noticed any adverse effects so far and we're now removing the original destinations..

c~
M.Drori
Occasional Contributor

Re: HPSIM 5

Were do I change or add the trap destination?
Craig McK
Trusted Contributor

Re: HPSIM 5

It's set on the properties of the SNMP service within Windows.
I've never used CIM7 though, can you replicate SNMP settings to multiple servers with that the same way HPSIM5 can? Would make it much easier to configure this en masse if you have that many servers =)