- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Systems Insight Manager
- >
- Hardware monitoring ALL steps
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2013 12:46 AM - edited 02-14-2013 02:28 AM
02-14-2013 12:46 AM - edited 02-14-2013 02:28 AM
Hardware monitoring ALL steps
Can anyone help me in understanding ALL the steps involved to get a server/device successfully under HP SIM monitoring so that if something related to hardware goes wrong on that server/device i should get an alert on HP SIM console
regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2013 01:04 PM
02-14-2013 01:04 PM
Re: Hardware monitoring ALL steps
Have you read any of the deployment/admin guides? It's too much to go over in a quick reply.
Basics:
- Understand the requirements of HP agents on every hardware platform you want to monitor (ESXi, Windows, Linux, etc)
- Understand the protocols you want to use for each of those platforms (SNMP, WBEM, SSH, WS-MAN, etc)
- Understand the security requirements (network ports, user accounts if needed, based on the protocols you want to use)
- Understand the requirements for discoveries (agents, SMH, protocols in use, whether to use global/system credentials)
- If using non-HP devices, understand how to add custom MIBs to SIM (sometimes provided by other vendors)
You really need to figure this out before you start adding stuff into SIM. It will make your deployment much easier if you have everything in line with your strategy first, especially if you have a mixed environment and a lot of devices.
The basic flow is:
- Agents/iLO => SMH/SIM via some data source (SNMP or WBEM for example)
- Events are generated from iLO/Agents and sent to the SMH and SIM via some protocol (again, SNMP or WBEM for example)
The above varies per platform. ESXi uses WBEM only, Windows can use SNMP/WBEM or both (not recommended) - again you need to figure this out before starting your deployment. The guides are fairly clear on all this...