- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Systems Insight Manager
- >
- Monitor Hardware with HP SIM
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2014 11:34 AM
11-13-2014 11:34 AM
Monitor Hardware with HP SIM
Hello Team,
I want to monitor hardware of all HP servers in my network through HP SIM.
Like if there is any failure or problem in any hardware part of my HP server, it should send a mail to specifed email address.
I know I can do this by automatic event handling but i dont know what to select in the event category or type.
It should send a mail whie any failure in Hardware part like hard disk, RAM, motherboard, planner, floppy drive, network card.
It should send a mail if any hardware part is in degraded state.
Waiting for reply
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-13-2014 02:22 PM
11-13-2014 02:22 PM
Re: Monitor Hardware with HP SIM
Simply set the event handler for critical or Important events. let it run for a while and you will see all relevent events then you can filter. Alternatively simply generate some failures and look at the events generated. Each event lists the .mib it comes from.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2014 06:18 PM
11-26-2014 06:18 PM
Re: Monitor Hardware with HP SIM
Is there any steps by steps guide in how to configure HP SIM to perform company wide server monitoring ?