HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Server Management - Systems Insight Manager
cancel
Showing results for 
Search instead for 
Did you mean: 

SW Unknown HPSIM7.3

 
Ter3x
Occasional Visitor

SW Unknown HPSIM7.3

Hey All,

 

I ave HPSIM 7.3 installed which is monitoring SNMP for all of my devices which seems to work fine, however, software portion doesn't work at all. I have tried assigning baselines than run data collection and software pull but no luck software is still unknow.

 

I am able to see current installed software via HPSIM but it doesn't show latest software available. 

 

Can someone shed some light on this please? Its getting frustrating going in loops over and over.

 

Thanks

2 REPLIES
Andrew_Haak
Honored Contributor

Re: SW Unknown HPSIM7.3

Hello,

Are your server Windows or Linux. The Windows servers should if possible be dicovered with WBEM. Look if all software is seen when you look at installed software. Did you use the software firmware baselines in SIM. Could you show a picture of the screen you see this. I've also battled with the software status that seemed to return to a question icon after beeing green before.
Kind regards,

Andrew
LGentile
Trusted Contributor

Re: SW Unknown HPSIM7.3

Are you using the version control agent (VCA)?  There is some additional setup required to get that all working.  It's going to be in the Version Control Repository section of the admin guide.