HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

VMM

 
Chris M. von Collenberg
Occasional Visitor

VMM

I've installed and configured the Virtualization Management Pack per the instructions but am unble to view guest VM's on the host server through SIM.

I am receiving the message, "Could not contact the VMM service". I verified that the agent service is running on the VM Host but the VMM service on the CMS moves to a stopped state after several minutes. Nothing is being recorded in the event logs on the CMS.

Am running SIM 5.0 SP4 on Windows 2003, VMM version 2.0.2

Any help would be appreciated.

3 REPLIES
Rob Buxton
Honored Contributor

Re: VMM

What's the VM Software? the current version of VMM doesn't support VMWare ESX 3.0/3.0.1

VMM 2.1 is due very soon that does support this.

Generally I've seen the above error when the VMM Service has died. The reason I found for this here was a Port Conflict, one of our Trend Micro products was grabbing a port VMM uses. Check the HPVMM Log.
Chris M. von Collenberg
Occasional Visitor

Re: VMM

I checked the logs and I am having a port conflict with Trend. How can I change/specify which port VMM uses?
Rob Buxton
Honored Contributor

Re: VMM

In the short term just stop the Trend Service, restart the VMM Service and give it a couple of minutes and then restart the Trend Service.

For a longer term solution see the thread:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1037019
And look for a response I got from Neeti.

If this fixes your issue I may need to give him double points!