VMware VirtualCenter Settings display blank page

[dtmoraug]

We run WMWare ESX-server 3 and Virtual Center 2.01. We wish to integrate this with HP SIM.
We have installed HP SIM 5.0 with SP5. Under the installation of HPSIM, ver 2.02 of Virtualization Management Software was installed. Under the installation we choose to Configure VMWare VirtualCenter Setting Later. After the SIM installation was complete we install Virtualization Management Software ver 2.1 This installation uninstall the 2.02 version before the installation begin.
After the installation of Virtualization Management Software 2.1 software was completed, we discovered our VMWare-servers in HP-SIM and deploy VMM-agent to these two servers. Next step is to Configure VMWare VirtualCenter through HPSIM. When we choose Options> Virtualization manaagement> Security> VMware VirtualCenter Settings, only a blank page is displayed. What's wrong

[Rob Buxton]

It does take around 30 seconds for the page to come up. Well it does here.

[Ole Thomsen_1]

If patience doesn't help, have a look at http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1089444&admit=-682735245+1168504413747+28353475

Ole Thomsen

[dtmoraug]

Thank You. Uninstall/Install Virtual Managment Software fixed this problem