HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Server Management - Systems Insight Manager
cancel
Showing results for 
Search instead for 
Did you mean: 

Version Control Agent for Windows Installation Failure

 
M. Daugherty
Occasional Visitor

Version Control Agent for Windows Installation Failure

I am not able to get the Version Control Agent to install. I have run the entire Support Pack installation and everything else installs fine with the exception of the Version Control Agent. I have also run the individutal executable with the force switch and the results are the same. The errors that I get are: The software is not supported for installation on this system. The SNMP Win32 service was not found by the installer. SNMP is running on the server.
2 REPLIES
Daniel Leblanc
Honored Contributor

Re: Version Control Agent for Windows Installation Failure

Remove SNMP,reboot and Reinstall SNMP

1 All you re server SNMP setting are set for TRAPS>Communite name(correc name),TRAPS>Communite name>traps destination> 1-server Insight & 2-127.0.0.1
#2 All you re server snmp setting are set for SECURITE> Accepted community name>Communite name(correc name),All you re server snmp setting are set for SECURITE> Accepted community name>Communite name> Accepted packet from these host>1-server Insight & 2-127.0.0.1.

3# in youre Home page manegement>Setting>Securite
A_IP Binding-Nothing
B_IP Restricted Login-Nothing
C_Local Server Certificate-Nothing
D_Local/Anonymous Access-Nothing
E_Trust Mode>Secure Trust Modes:Trust by Certificate
F_Trusted Management Servers>Importe you Insight server certificate
G_User Groups-Nothing
M. Daugherty
Occasional Visitor

Re: Version Control Agent for Windows Installation Failure

Thanks for that info. I will give it a try this morning.