Version Control repository manager stop working

[Gareth H Wilson]

Since going to 5.2 we have found that if we go to a servers SMHP and then into the version control agent page and start pushing drivers out from there after about 10 installs the VCRM then stops working on the hp sim server(the clients running the SMHP just say the VCRM cannot be contacted) and if i look on the SIM server the service is running fine and so far the only way to get it back running is to physically bounce the SIM server as doing a restart of the VCRM service doesnt fix it.

Anyone else seeing this ?

Cheers in advance

[Ervinck Kevin · Accepted solution]

This is a known issue.

Uninstall the SMH and VCA on your HP SIM server an roll them back to versions from Support Pack 7.91.

[Gareth H Wilson]

ok have done that will keep an aye on whether the VCRM stops allowing connections again